Completed work
CVRT Scimitar exhibition hub cap replacements
A metal hub cap was used as the reference for a plastic recreation for a CVRT Scimitar exhibition vehicle. The project shows the original comparison, the finished cap, a wheel trial fitting and workshop videos. It records the exhibition project and the demonstrations shown.
Enlarge photographAn exhibition-vehicle recreation
A metal original provided the reference for this plastic hub-cap recreation for a CVRT Scimitar exhibition vehicle. The project is shown in that exhibition context. The original-and-replacement photograph makes the change from the metal reference to the white plastic recreation visible.
From comparison to finish and fit
Further photographs show a green finished cap with a gasket and the recreated part being trial fitted against the wheel. The short fitting video gives another view of the cap in relation to the existing wheel. Together, these records show more of the work than a single finished-part photograph could.
The mallet demonstration
A separate workshop clip shows the recreated tank hub cap being struck with a mallet. It records that particular demonstration and does not establish a measured impact rating or a wider load capability. For another hub, cover or exhibition part, explain the intended use and the features that need to match the original before the work is agreed.
A closer look at the parts
Enlarge photograph
Enlarge photographWatch the workshop videos
Scimitar exhibition hub cap trial fitting
Tank hub cap mallet impact demonstration
Before ordering a replacement
What affects the price of a replacement part?
The quote depends on the design work, the reference information available, the features that control the fit, the manufacturing requirements and the quantity. An unclear or incomplete reference can require more work to establish the design. Design is usually quoted first with an estimated manufacturing price; the final manufacturing price is confirmed after design, before production is approved and paid for.
When is recreating a part worth considering?
It is worth discussing when a suitable standard spare is unavailable or difficult to source and the rest of the equipment remains useful. The decision depends on the work required, the intended use and the cost of other options. Send the equipment details and photographs so the proposed work and price can be considered before you decide.
Can I order more copies later?
Manufacturing files can be retained for future copies. Discuss this when agreeing the work. Where an established design is available, a repeat order can avoid recreating the same design from the beginning. Further quantities, changes, manufacturing prices and postage still need to be agreed for that order.
Can you help if the original part is missing?
Sometimes. A matching component, photographs, drawings or measurements of the place it fits may provide a starting point. Matthew needs to assess whether there is enough information to establish the design. If important details cannot be determined, an exact recreation may not be possible. Start with the references you have and explain what the replacement needs to do.
Have a similar exhibition-vehicle part?
Send photos and a short description. Matthew will discuss the next steps.